Sorry for the double post, I originally put this in the wrong area.
Just wondering if there is an ability to replace a parametric cell with another one. I can see the update cell definition and that works for updating the current cell.
I was trying to replace it with another one but it doesn't look to work. I can understand why this could be an issue for the constraints but thought maybe there is a way.
Parametric cells are going to be fantastic on façade panels with slight dimensional changes, say width of a couple of panels at the end. From my initial testing you could use the same cell throughout and just change the width variable, updating doesn't change it back so you can update the parametric cell as the design progresses without having a large number of cells due to small dimensional differences.
Thanks
Wayne