How do I get my vertical bracing symbols to show up in my framing plans when they are below the floor?
Bay with beams and bracing turned on
Image may be NSFW.
Clik here to view.
Bay with beams turned off
Image may be NSFW.
Clik here to view.
I am using a structural rule for the beams and another for the bracing.
The beams are using a pretty standard single line + section name rule whereas the bracing rule is using a special rule my trainer helped me develop that uses the User Defined label for the XX's which I add to each vertical brace.
Image may be NSFW.
Clik here to view.
I am assuming that the geometry of the beam is hiding the geometry of the vertical bracing, but I'm at a loss for how to get my bracing symbols to show up along with the beams despite this.
I appreciate any help.
Thanks,
Ben