I have a lot of models in Microstation in 3D. These are 3d solids for mechanical ducts. Is there a way to convert this 3d solids into real mechanical ducts. Because the sizes of the solids are real duct sizes. So the coordinate of the 3d design is in milimeter. Example is I have placed a slab with X,Y en length is Z. So the dimensions of the known. If you start AecoSim and to change the slab into duct. Is this possible. And is it possible to select the slab and change this into a AecoSim duct. And also with cylinder information.
↧
