Hi everyone
We have some questions about compuond cells
1. Updating
We understand the right way for updating in the drawing a DG CC system is DG explorer, does it? Is there another way? The replace cell tool is only for non DG CC?
2. Placing
Why are there so many options when you insert with normal tools a CC in the drawing and when you insert them through DG cells there are no options?
3. Perforators
Sometimes we have created cells with two perforators with different perforation depths. We use the "mysterious, enigmatic" and useful way explained in this video by Steve
http://communities.bentley.com/products/building/building_analysis___design/f/5917/t/111895
We insert this CC in the drawing through DG tools. The problem is if you update this CC through DG explorer these differents depths dissapear. Is there anyway to avoid this?
4. CC and datagroup
Every time we create a CC and we added it to DG we have the same problem. When you use the DG tool to insert the new CC it never appears in the list of available elements. We must close the ABD and restart it in order to make it appears in the list and use it. Is there any way to avoid that?
Lots of thanks
Regards