System fault 126
Hi,In a Dynamic View we want to change the visible edges setting in the reference file dialogbox from "Dynamic" to "Cached". ABD start to recalculate the visible edges and stops after 85% with a...
View ArticleRE: Offsetting 3D lines
Apologies, I wasn't too clear before, the offset of the rail string isn't to get the other rail line. It's offset so the platform edge can be set and then all 3D work is completed from this. So, I need...
View ArticleRE: Offsetting 3D lines
Saying that, I have just discovered an offset Surface command. So by copying the line up by a specific distance and then lofting the 2 lines I create a surface, which can then be offset and it appears...
View ArticleRE: Offsetting 3D lines
Hi Davulsukur, That is a good solution. You could also extrude the whole profile of the operating envelope along the alignment as a solid and use it for clash testing against other elements.
View ArticleOffsetting 3D lines
Seems to have been asked a few times in the past but what's the deal with offsetting 3D lines (with varying Z values at vertex points)If I used the move parallel command (in top view) to offset a line...
View ArticleClik here to view.
RE: Changing floors relative elevation
Rafael,It works in CONNECT Edition - Version 10.00.00.154.Also in SS6 - Version 08.11.09.866Make sure you are setting the negative elevation in the Elevation field, not the Relative Elevation field....
View ArticleRE: Changing floors relative elevation
Hello Larry, Thank you for your repply, I'm working at the CONNECT Edition now. The only problem is that my Datset is empty, no elements in the catalog, and I cannot add any floors to the previous...
View ArticleRE: Changing floors relative elevation
Rafael, So you can't even place a wall or door? What dataset did you select when you entered the file? Larry
View ArticleRE: Changing floors relative elevation
I upgraded from "ABD Release Candidate" to ADB CONNECT. Then I downloaded ADB CONNECT from the Student Server, (it didn't specify what Dataset it was using), then I started a Workspace and a Workset...
View ArticleRE: Changing floors relative elevation
Hi Rafael,Did you remove the previous ABD CONNECT before installing the commercial release?See CONNECT Edition - Preparing for Installation and Configuration for more information.
View ArticleRE: Changing floors relative elevation
Did you remove the Release Candidate before you installed the released version? If so, please look at this Wiki article about the configuration changes from a V8i project to CONNECT...
View ArticleRE: Changing floors relative elevation
Yes, I did remove the Release Candidate before Installation....I didn't knew that was going to generate problems.
View ArticleRE: Parametric Content Creation
Borja, We are still working on this. The development initially titled "Bentley Parametric Content Modeler" was rolled in to CONNECT Edition where as the parametric modelling toolset. There is more work...
View ArticleClik here to view.
RE: Changing floors relative elevation
It doesn't cause any problems - It's required in case things changed between the Release Candidate and the official Release. Do you get items like Walls, Doors, and Windows for placement? If so, then...
View ArticleChanging floors relative elevation
Hello Good Bentley CommunityI just wanted to ask how can I change the relative elevation of floor, in order to be able to add underground floors (for parking or something similar)When I try to do it it...
View ArticleClik here to view.
RE: New discipline in Datagroup Explorer
Hi Davulsukur, The New Service Request option is located at the bottom right corner of your Bentley CONNECTION Center page:https://connect.bentley.com/ Note that this will require you to log on using...
View ArticleNew discipline in Datagroup Explorer
Is it possible to create a new discipline in the Datagroup explorer?So a Civil Engineering one (for example) to go along with Structural, Architectural etc.
View Article